9
The flicker reduction switch (3 position):
- When set to the lower position, flickerfree mode FF is activated and the green LED is lit. This mode is
designed to produce a flickerfree image for camera speeds above 10fps.
- When set to the middle position, flicker reduction is off and the green LED is not lit. The video assist is
in normal mode.
- NTSC - When set to the upper position, flickerfree mode FF30 is activated and the green LED is lit. This
mode provides a 100% flickerfree image when operating at a camera speed of 29.97 fps or 30 fps. In this
mode, flickering is reduced by 70% for camera speeds other than 29.97 fps and 30 fps.
PAL - When set to the upper position, flickerfree mode FF24/25 is activated and the green LED is lit. This
mode provides a 100% flickerfree image when operating at a camera speed of 24 fps or 25 fps.
Flickerfree modes FF , FF30 (NTSC) and FF24/25 (PAL) will only be active when the camera is running.
Once the camera is stopped, normal mode will resume.
White balance switch (3 position):
- Lower: 5600K (fixed) - for outdoor shooting on sunny days.
- Middle: 3200K (fixed) - for indoor shooting under incandescent light.
- Upper: Auto White Balance is ON. The white balance is adjusted according to the color temperature
transition of the subject. This mode is suitable for shooting with variable lighting.
Integrated B&W or Color Video Assist for Arriflex 16SR (Reg16 or Super16)
The CCD image sensor and video assist electronics are mounted inside the camera body. The control
module with switches and output connector is mounted on the camera's side. The power necessary to supply
the video assist is taken internally from the camera's 4 pin XLR power input receptacle. The internal image
sensor installation provides a picture on the monitor screen that is brighter and sharper than that of the T-bar
or modified J-bar video tap because the CCD image sensor is installed closer to the fiber optic viewing
screen. The viewfinder image is also brighter because the exposure meter's beamsplitter is removed and
replaced by a brighter pellicle T70/R30 type beamsplitter. The video optics is independent of the viewfinder,
so the video image is stable even when the viewfinder is rotating. This installation requires that the entire
exposure meter section be removed from the camera body. We can install this video assist in NTSC or PAL
format.
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales